Fluance AB40 - Certification and Compliance Information; FCC and IC Regulatory Statements

10
What does the “3D” toggle do?
The 3D toggle will enable or disable the 3D Virtual Surround Sound mode. The Virtual
Surround Sound mode uses a 3D algorithm to create a wider more room lling
soundstage. This technical Grammy award winning software combined with angled
drivers on each side of the cabinet result in a superb immersive experience.
How do I adjust the Volume / Change the EQ settings?
Use the +/- buttons on the remote or touch panel located on the cabinet to increase
or decrease the volume accordingly. The range of volume is 0 to 40. To adjust the
EQ settings either select STANDARD or BASS BOOST on the remote control to select
your desired EQ setting. STANDARD EQ is the Soundbase default EQ. It has been
designed for an ideal audio experience across all applications. BASS BOOST EQ
increases the volume of the low end frequencies, resulting in a more impactful
experience.
What is “Auto-Pairing” and how does it work?
Auto-Pairing is a convenient connection feature implemented into all Fluance
Bluetooth Speakers. If the connected Bluetooth enabled device leaves the connection
range of the AB40 and returns at a later time, the device will automatically connect. If
the device’s Bluetooth function is disabled and then enabled at a later time, the device
will automatically connect as well.
*Note that the Fluance Soundbase will only Auto-Pair to the last device that it was
connected to.
How do I change the input of the Fluance Soundbase?
Press the SOURCE button on either the remote or touch panel of the cabinet to cycle
between AUX, Optical, and Bluetooth inputs. You can also press the Bluetooth button
on the remote to switch directly to Bluetooth mode.
What does the LED color/behavior mean?
GREEN = 3.5mm AUX input
WHITE = Optical input
BLUE = Bluetooth input
If the LED ashes once it means that the Soundbase has received the command from the
remote or touch panel.
Another device is connected to the AB40 and I wish to connect my device.
You can reset any Bluetooth connection by pressing and holding the Bluetooth®
button on the remote. The AB40 will be available to connect to any new device for
the next 30 seconds. If no device is found, the AB40 will auto-pair back to the
previously connected device.
*Note only one device can be paired at a time.
FAQ