Fluke 6062A - Page 42

The following information
describes how
to enable the
output of the
Generator
using the RF
OUTPUT
[ON/OFF] key and the corresponding
remote
code.
Command Syntax:
RF Output On/
Off
Summary:
COMMAND
NOTE
RF
Output On
Local:
RF OUTPUT CON/OFF3 when RF
OFF is on
1
Remote:
"R01"
1
RF
Output Off
Local:
RF OUTPUT CON/OFF3 when
RF OFF
is off
Remote:
"ROD"
Note:
1.
Turning the RF
Output on resets the RPP
circuitry if
it has tripped.
2-32.
Special Function Entry
The following information
describes how to
use the Special Function
Entry to
use the special
operating functions
of the Signal
Generator. Table
2-4
lists the special
functions available.
The special function
code is a two-digit
number. The first
digit indicates
the classification
of
the
special function, and the
second digit specifies
the particular
special function.
The special function
is executed
when the second
special function code
digit
is
entered.
There
are ten classes
of special functions. The
special functions in
the 0(n) and
l(n)
class
cause
an
action to be performed.
Classes
2(n) through 9(n)
cause an instrument
state to change.
The
status
of classes 2{n) through
9(n) appears (left
to right) in the
frequency display
field when the
[SPCL] key is pressed.
Table
2-4
describes
the special functions
available
with the Generator.
Command Syntax:
Select
Special Function
—
Enter Special Function
Code
COMMAND NOTE
Local:
CSPCL3
—
Inl Cn3
Remote: "SP”
—
int 1
Example;
Change
the repeat rate
of the EDIT
and
STEP
keys to
slow.