Fluke 6062A - Page 48

INSTALLATION AND OPERATION
Table 2-8.
IEEE-488
Commands
COMMAND COMMAND
COMMENTS
USE HEADER NUMERIC SUFFIX
AMPLITUDE ENTRY
Program AP
f 1 oat Program displayed amplitude
AmpLi
tude in units of:
V volts
MV millivolts
UV mi crovolts
NV
nanovoLts
DB
dB,
dBm^
dBmV
or dBuV
Convert AP none Change amplitude units to;
Amplitude
V volts
Units MV volts
UV volts
NV volts
DB
dB, dBm^ dBmV or dBuV
Relative
SP 30/31 none Disabie/enable relative
Amplitude
amplitude operation
Relative RA 0/1 Alternate programming command
Amplitude
for disable/enable relative
amplitude
operation.
Amplitude
SP 50 none Select dBm units
Di splay 51 Select dBmV units
Units
52
Select
dBuV units
Level
SP 80 none
Enable
all Level correction.
Correction
81
Disable
all level correction.
82 Disable attenuator correction.
Amplitude
SP 90/91 none Disabie/enable amplitude
Fixed
Range fixed-range operation.
BINARY LEARN COMMANDS
Store a LI int
string
The Generator stores the
Front Panel
string
into the
memory
Setup
Location specified
by
int.
See the Command Description
paragraph for decoding the
Learn string.
Send a LM int none The Generator responds with
Front Panel the
contents of
the memory
Setup Location specified by int.
See the
Ccxnmand Descriptions
paragraph for
decoding
the
learn string.
CLEAR COMMANDS
Clear
IEEE-
CB
none none
Clears IEEE-488
output
488
Output
Buffer
buffer.
Clear error CE none
none Clears
the IEEE-488 rejected
entry status.
2-32