1586A
Calibration Manual
16
Unlock the Product with a Remote Interface
To unlock the Product with a remote interface, send the command:
CAL:SEC:STAT OFF,“1586”
To relock the Product, send the command:
CAL:SEC:STAT ON
Reset the Admin Password
If the admin password is lost or forgotten, the password can be reset to 1586 with
these steps:
Note
Before doing these steps, try to use the factory default password:
1586.
1. Do the general disassembly steps in the Disassembly section.
2. Connect a jumper across J8, as shown in Figure 7.
3. Reconnect the mains power cable between the Product and a power outlet.
4. Turn the on the Product.
5. When the Product is started, the password will automatically be reset to
1586.
6. Turn the Product off and disconnect the mains power cable.
7. Remove the jumper connected in step 2.
8. Reassemble the Product by doing the reverse procedure in Disassembly.
To Next Page
Loading...