Fluke SUPER-DAQ 1586A User Manual

July 2014 Rev. 1, 4/24
© 2014-2024 Fluke Corporation. All rights reserved. Specifications are subject to change without notice.
All product names are trademarks of their respective companies.
1586A
SUPER-DAQ Precision Temperature Scanner
Calibration Manual

Fluke SUPER-DAQ 1586A Specifications

General

Measurement Types	DC Voltage, AC Voltage, Resistance
Temperature Accuracy	±0.05°C
Resistance Range	100 MΩ
Current Range	1 A
Isolation	300 V
Interface	USB, GPIB
Power Supply	100 V to 240 V, 50 Hz to 60 Hz
Memory	Internal memory for data storage
Display	Graphical LCD

Summary

Introduction to the Fluke 1586A

Safety Information

General and specific safety information for using the product.

General Maintenance Procedures

Troubleshooting: Product Not Turning On

Troubleshooting steps if the product fails to power on.

Static Awareness and Handling

Required Equipment for Calibration

Front Panel and DC Volts Verification

DC Volts Verification Steps

Steps to verify DC voltage measurements using test equipment.

4-Wire Ohms Verification

PRT Verification Procedure

Thermistor Verification Steps

DC Current Verification

CJC Module Accuracy Verification (1586-2586)

Calibration Adjustment and Product Unlock

Remote Interface Unlock and Password Reset

Resetting the Admin Password

Procedure to reset the admin password if it is lost or forgotten.

Remote Commands for Calibration

Specific Calibration Procedures via Remote Commands

Calibrate 1 V DC Range Only

Command References