Fluke TiS Series User Manual

QuickStart: FLUKE TiSXX
© 2017 The Snell Group / 322 N. Main St. / Suite 8 / Barre, VT 05641 / 800.636.9820 / www.thesnellgroup.com
1
1. MEMORY: Insert SD memory card into the slot under the rubber cover on the top of the camera.
2. POWER: Insert a fully charged battery into the base of the hand grip. The battery life is indicated in the bottom
left corner of the LCD display. You can also press and hold the battery symbol on the side of the battery.
3. START: Press the Power button until you hear an audible tone signaling camera startup.
• Swing the attached lens cover up and lock in the open position on the top of the camera.
• The LCD display will turn on and you will see the default start up screen (as above) showing a live infrared
image.
• To turn the camera off, press the Power button until an audible tone signals it is powering down.
4. FOCUS: Focus is manual.
• To manually focus, adjust the focusing ring either clockwise or counter clockwise to optimize image focus
5. AUTO ADJUST (Level and Span): Auto Level and Span can be selected two ways. If operating in Manual
Mode, depress and hold the F1 button and the imager will change to Auto mode.
• Auto mode is additionally accessible through the menu screens. Depress the F2 button to open the Menu, and
with the directional buttons select Measurement. Then select Set Level/Span. To select auto, highlight it with
the directional buttons and then depress F1.
6. MANUAL ADJUST (Level & Span): Manual Level and Span can be selected two ways. If operating in Auto
Mode, depress and hold the F1 button and the imager will change to Manual mode.
• Manual mode is additionally accessible through the menu screens. Depress the F2 button to open the Menu,
and with the directional buttons select Measurement. Then select Set Level/Span. To select Manual highlight
it with the directional buttons and then depress F1.
• While in Manual mode, a one-time auto adjust of level and span can be made by depressing the F3 button.
F1 F2 F3
Level & Span
Indicator
Center Spot Temp.
Indicator
Memory Card Slot
Power/Charge
IR Focusing Ring
Trigger
(Pause/Un-pause)
Battery Life
Indicator
Auto/Lock
Mode Indicator
Lens Cover
(Swing up and lock)
Power Button

Fluke TiS Series Specifications

General

Brand	Fluke
Model	TiS Series
Category	Thermographic Cameras
Language	English

Summary

Camera Setup and Basic Operation

Memory Card Installation

Insert SD memory card into the slot under the rubber cover on the top of the camera.

Camera Power and Battery

Insert a fully charged battery. Battery life is indicated on the LCD.

Starting and Turning Off the Camera

Press the Power button until an audible tone signals startup or shutdown.

Manual Image Focusing

Manually focus by adjusting the focusing ring clockwise or counter clockwise.

Auto Level and Span Adjustment

Select Auto Level/Span via F1 button or through the menu screens.

Manual Level and Span Adjustment

Select Manual Level/Span via F1 button or menu. Use F3 for one-time auto adjust.

Image Management and Settings

Pausing and Saving Images

Pause live images with the green trigger. Save images by pressing F1.

Recalling Saved Images

Use the memory view button and directional buttons to recall desired images.

Image Palette Selection

Select Image, then Palette via the menu to choose from available color palettes.

Emissivity Adjustment

Adjust emissivity manually or select from a table of common materials via menu.

Background Temperature Correction

Adjust the background correction factor through the Measurement menu.

Transmission Correction

Adjust the transmission correction factor via the Measurement menu.