Fluval SEA EVO - INSTALLATION GUIDE; Connect Pump and Insert Filter Media

INSTALLATION
Ax pump to tubing and lower into corner of rear chamber. Next, feed
the output nozzle through the hole in the filter wall and screw into elbow.
Thoroughly rinse Carbon and Biomax media. Next, insert
Carbon in top Foam Bio-Foam compartment, and Biomax in
bottom compartment. Using the handle, lower entire foam
filter block unit into rear filter compartment (as shown
above).
Step 1. Connect pump to outlet
Step 2. Insert Filter Media
Foam Filter
Block
Carbon
Insert
Biomax
Insert