Flux FLUXTRONIC - Page 45

Attachment FLUXTRONIC Automatic Mode 45 / 84
ENGLISH
5. SET
General settings
5.1 Change decimal place [S1] and [S2]
The decimal place, that is set here, applies to both quantities.
5.2 Change security level [LOC]
The LOC setting can be used to protect the ranges from inadvertent changes. There
are 5 security levels, "0" meaning no security and "4" meaning maximum security.
5.3 Change PIN number [PIN].
A 3-digit PIN number can be issued once the security level has been selected. This PIN
number must then be entered each time that a protected range is processed. The PIN
number can also be "000".
Item
LOC
START
TOT
FLO
CAL
SET
4
PIN
PIN
PIN
PIN
PIN
3
OK
PIN
PIN
PIN
PIN
2
OK
OK
PIN
PIN
PIN
1
OK
OK
OK
PIN
PIN
0
OK
OK
OK
OK
OK
Forgotten your PIN?
Reset security level [LOC] to 0 and
Reset PIN number to "000"
All other entries are retained.
1. Remove battery from the battery compartment.
2. Press the Stop key before inserting the battery and hold it down while it is being
inserted.