Flux FLUXTRONIC - Page 47

Attachment FLUXTRONIC Automatic Mode 47 / 84
ENGLISH
5.9 Change pulse redirection [ ]
Pulse redirection is intended for other applications or units that can also process
the input pulse from the electronic analysis unit. The input pulse is processed by the
FLUXTRONIC and converted into a rectangular pulse without contact bounce and
then emitted. An isolating amplifier with a NAMUR input, capable of switching up to
150 Hz, is needed to use this signal.
5.10 Reset all settings to default values [DEF]
The following settings are entered when all settings are reset to default values.
Area
Designation
Action
START
Volumes to be filled [S1] at
memory 0 .. 9
Deleted
START
Memory location [BC]
0
TOT
Total volume
Deleted
TOT
Decimal place [DEC]
0
FLO
Time unit [UNIT]
min
FLO
Decimal place [DEC]
0
FLO
Gate time [GATE]
3.0 s
CAL
Memory [CAL]
0
CAL
Setting value [SET]
All memories to 0.0500000
CAL
Unit [UNIT]
All memories to "L"
CAL
Decimal place [DEC]
0
SET
Decimal place [S1] and [S2]
1
SET
Security level [LOC]
0
SET
PIN number [PIN]
000
SET
Volume [S2]
OFF
SET
Err
OFF
SET
Ext
OFF
SET
OK
OFF
SET
AC
OFF
SET
Pulse redirection [ ]
OFF