SETTING E-GIVE
There are 6 settings for E-give, 0 through 5. Change the setting by swipping down and up on the bars.
The higher the setting the higher the amount of give. 0 = no give, 5 = maximum give.
E-GIVE INDICATOR
The number displayed is the current E-give setting.
ADDITIONAL INFORMATION
VOLTAGE PARAMETERS
While voltage is a parameter that will vary from artist to artist, this machine has been tested to
operate at a minimum voltage of 5 Volts and a maximum voltage of 12 Volts.
Depending on the type of needle configuration or brand you use, feel free to adjust the voltage to
obtain the desired performance.
ACCEPTED NEEDLES
Use only cartridge needles with an internal membrane. This will avoid accidental contamination inside
your machine. Fluids such as ink, water or oil will void warranty of the device and may require
replacement of internal parts.
MAINTENANCE
Flux is sold pre-lubricated from factory and does not require internal lubrication.
Prevent any type of external elements from entering inside the machine as they will disrupt the
motion of the component and contaminate lubrication.
The grip of the machine is autoclavable. Use only steam autoclaves at temperatures no higher
than 270° Fahrenheit or 132.222° Celsius. Add a hint of ointment or PTFE grease around internal
opening of grip or on stabilizing friction O-rings for optimal functionality after autoclaving.
Machine Body and PowerBolt can be sanitized from the outside with cold sterilization products.
Never spray the surface directly to prevent fluids from entering the machine. Always use pads or
disposable paper towels to apply sterilization products.
To Next Page
Loading...