1 1
FLX.BIKE
21
lCD sCreeN iNstruCtioNs
To turn on the LCD, press and hold the “Power Button ( )” for 3 seconds. Once this is done
the “Power Level” section of the screen will display the current level of pedal assist active.
The default is 0, and the maximum is 5. The level of pedal assist can be adjusted by pressing
the “+” or “-” buttons as appropriate. When the LCD is on, the throttle will also be active, and
this can be triggered regardless of the level of pedal assist (1-9) by depressing the throttle
lever on the left hand grip of the handlebars.
Note: the throttle may only be engaged when riding above 6mph (10KM/H).
Additionally, walk-assist mode can be activated by pressing and holding “ - ” for 3 seconds.
This is a single-speed designed to be an average walking pace, NOT FOR RIDING.
When full, the “Battery Indicator” will show a full battery icon and numerical indicator
“100%”. When the battery drops below 10%, the battery icon becomes red, which indicates
that it has to be charged.
The headlight, taillight and backlight on the LCD screen can be activated by pressing and
holding the “Light ( )” button for 3 seconds, and it can be turned o the same way.
To charge USB devices via the display’s USB port, remove the rubber seal on the bottom of
the display and insert any USB charging cable.
D
To Next Page
Loading...
