Flybar FB101627 - User Instructions; Pre-Use Setup and Battery Connection; Battery Charging Procedure; Operating the Bumper Car

USER INSTRUCTIONS
BEFORE USE
• Remove the two screws from the seat cover and lift out the cover.
• Connect the battery terminal. You must connect the same color wires together: black
connector to the black terminal, red terminal to the red connector. Make sure they are
connected with the correct polarity.
• Replace the seat cover with the two screws and tighten.
CHARGING THE BATTERY
• Plug the charger into a standard 120v wall outlet and the
wire end into the charger port.
• Fully charge the battery for 8-12 hours. Indicator light, located on the charger,
will be Red if vehicle is not fully charged. Once vehicle is fully charged, indicator
light will turn Green.
• Do not charge the battery for more than 12 hours.
• Check the battery and charger for any signs of wear or damage
before use and do not use if damaged.
OPERATING THE VEHICLE
• Press the power switch to turn the vehicle on
• Push or pull the control joysticks to move the vehicle
• Release both control joysticks to stop the vehicle completely
WARNING: Close supervision is required when child is operating the vehicle.
FLYBAR_BUMPER_CAR_OWNERS_MANUAL_V2.indd 6FLYBAR_BUMPER_CAR_OWNERS_MANUAL_V2.indd 6 5/14/21 1:18 PM5/14/21 1:18 PM