IMPORTANT ASSEMBLY INFORMATION
Before beginning assembly, carefully read all instructions. For help
identifying small parts, see the EXPLODED VIEW and PARTS
LIST. As you assemble your product, make sure all parts are ori-
ented as shown in the drawings. Place all parts in a cleared area
and remove the packing materials. Do not dispose of the packing
materials until assembly is completed.
It is strongly recommended that this equipment is assembled
by two or more people to avoid possible injury.
Securely tighten all Nuts and Bolts after all components have
been assembled onto the bench. Do not tighten each bolt right
after it is installed.
All required M8x16 Bolts of this product have been prein-
stalled.
Do not over tighten any component with pivoting function.
Make sure the pivoting component is able to move freely.
Make sure the M10 Knob is inserted completely through the
upright beam and turned to a locked position when adding
weights on it.
6
To Next Page
Loading...
