Flycam HD-5000 User Manual

Handheld Video Stabilizer
I N S T R UC TI O N M A N U A L
All rights reserved
No part of this document may be reproduced, stored in a retrieval system, or transmied by any form or by any
means, electronic, mechanical, photocopying, recording, or otherwise, except as may be expressly permied
by the applicable copyright statutes or in wring by the publisher.

Flycam HD-5000 Specifications

General

Brand	Flycam
Model	HD-5000
Category	Camera Accessories
Language	English

Summary

Attaching Camera and Post

Balancing the Stabilizer

Counter Weight System Purpose

Purpose of counter weights: balance camera weight against stabilizer's low end.

Weight Distribution for Balance

Heavier cameras need more weight; maintain balance by adding equal amounts.

Vertical Stalk Adjustment

Horizontal and Vertical Balancing Techniques

Horizontal Axis Balancing

Test horizontal balance on a flat surface; adjust camera/plate position for level.

Weight Warning

Adjusting for Front/Tail Heavy

Adjusting for Left/Right Lean

Counter Weight Disc Adjustment

Vertical Axis Balancing Detailed

Vertical Balancing Steps

Loosen screws, adjust camera fore/aft, ensure post is vertical.

Weight Disc Adjustment for Verticality

Stability Principle

Vertical Drop Time Test

Test vertical balance by timing the center post's return to vertical.

Interpreting Drop Time

<2s: bottom heavy; >2s: top heavy. Adjust weights accordingly.

Final Balancing and Setup

Preferred Drop Time

The preferred drop time for optimal vertical balance is 2-2.5 seconds.

Balancing with Full Setup

Balance requires the camera with all shooting accessories attached.

Camera Alignment

Weight Adjustment Iteration

Add weights in pairs, testing drop time until correct rate is achieved.

Fine-Tuning Balance

Fine-tune left-right and forward-backward balance by adjusting plates and post.