Flyingbear TORNADO User Manual

Flyingbear-Tornado Installation Manual
1.Frame installation------------------------------------------------------------1
2.Driving wheel and idler wheel installation---------------------------2
3.Y-liner guide rail installation----------------------------------------------3
4.X-linerguider rail installation---------------------------------------------5
5.Z-hot bed installation------------------------------------------------------10
6.LCD and other parts installation--------------------------------------13
7.Power installation----------------------------------------------------------15
8.Synchronous belt installtion-------------------------------------------16
9.Nozzle and tank chain----------------------------------------------------17
10.Extruder installation----------------------------------------------------18
11.Auto leveling installation(only if you have TL touch
option)---------------------------------------------------------------------19
12.Wring diagram------------------------------------------------------------20
13.Setting up slicing software------------------------------------------21
14.Setting auto leveling sensor----------------------------------------23
15.First print model--------------------------------------------------------24

Flyingbear TORNADO Specifications

General

Nozzle Diameter	0.4 mm
Layer Resolution	0.05-0.3 mm
Filament Diameter	1.75 mm
Connectivity	USB, SD Card
Frame Material	Aluminum
Printing Technology	FDM (Fused Deposition Modeling)
Heated Bed	Yes
Bed Temperature	Up to 110°C
Nozzle Temperature	Up to 260°C
Supported Materials	PLA, ABS, PETG
Power Supply	24V