Need help?Do you have a question about the Flyingbear P902 and is the answer not in the manual?
Choose the language for the Repetier-Host installation process.
Initiate the Repetier-Host software installation.
Review and accept the End User License Agreement for Repetier-Host.
Specify the installation directory for the Repetier-Host software.
Choose which optional components to install with Repetier-Host.
Define the Start Menu folder for Repetier-Host program shortcuts.
Select extra tasks like creating a desktop icon during installation.
Review and confirm installation settings before proceeding.
Finalize Repetier-Host installation and prepare for driver setup.
Begin the installation of necessary device drivers for the printer.
Confirm that device drivers have been successfully installed.
Extract and launch the FTDI driver installer package.
Start the process of installing device drivers on your computer.
Confirm the successful completion of FTDI driver installation.
Navigate to the printer settings interface within Repetier-Host.
Set up printer connection via COM port and baud rate.
Adjust printer feed rates, speeds, and temperature settings.
Define extruder properties such as number, name, and nozzle diameter.
Set the printer's maximum build dimensions and origin point.
Select Slic3r as the slicer and access its main configuration panel.
Understand and select print quality profiles and layer height.
Set filament diameter, extrusion multiplier, and temperature.
Adjust fan speed and cooling thresholds for optimal prints.
Save current filament settings as a reusable preset.
Configure printer-specific parameters within the Slic3r software.
Save current printer settings as a reusable preset.
Connect printer via USB and verify driver installation in Device Manager.
Open and prepare the Repetier-Host application.
Establish connection to the printer and monitor its status.
Move the printer's X, Y, Z axes to their home positions.
Adjust the nozzle-to-bed gap at each corner for proper leveling.
Perform final adjustments, check gap uniformity, and print a test object.
Learn about SD card printing and hot bed preparation.
Configure and slice the model using Slic3r for printing.
Save the processed model file to the SD card.
Initiate the printing process from the SD card after setup.
Tips for printing vase models, including quality adjustments.
General| Nozzle Diameter | 0.4 mm |
|---|---|
| Filament Diameter | 1.75 mm |
| Connectivity | USB, SD Card |
| Frame Material | Aluminum |
| Heated Bed | Yes |
| Bed Temperature | 100 °C |
| Nozzle Temperature | 260 °C |
| Extruder Type | Single |
| Power Supply | 24V |
| Print Technology | FDM (Fused Deposition Modeling) |
| Supported Materials | PLA, ABS, PETG, TPU |
| Display | LCD |
To Next Page
