Installation Instruction
FlyingBear P902 3D Printer
一
.Installation Steps of the 3D printer
1.Check the installation video in the folder of
“
installation video
”
, then follow the
steps to install it.
☆
You should pay attention to the details in the installation process,there are hints in the Installation
Video,you should watch the video carefully and follow the steps to install the machine.
☆
If you do not watch the installation video carefully,install it on your own mind and cause the machine
can not be used or even damage, we are not responsible for.
1.Some details during the installation process
☆
Z-axis
安装尺寸
the size of Z-axis
To Next Page
