Flyingbear P902 - Print Settings Overview

17
2
、“
Print Settings
”
parameter introduction
ColiDo Best
：
thickness 0.15mm
，
Suitable for printing small model and exquisite model
ColiDo draft
：
thickness 0.3mm
，
Suitable for fast printing
ColiDo standard
：
thickness 0.2mm
，
Suitable for printing large models
ColiDo standard ABS
：
thickness 0.2mm
，
Suitable for printing ABS
ColiDo support
：
thickness 0.15mm
，
Suitable for printing model needs to support
ColiDo thin wall
：
thickness 0.15mm
，
Suitable for printing thin-wall model below 2mm