Flyingbear P902 - Printing Your First Model; SD Card Printing Introduction

31
Ⅵ
.Print product
There are two ways to print: use the SD card to print and use the computer to print.
It is recommended to use the SD card to print. The computer will be standby or have other
abnormal situation to interrupt the printing process when use the computer to print.
Attention:The hot bed needs to paste the masking tape or painted with the self-adhesive
before printing.
1、Introduction of using SD card to print
Click the botton
，
load the folder
“
Test Model
”
in
“
FlyingBear 3D Printer