29
Step 4：With the printer powered off， Manually move the Extruder to one corner of the Heated Print Bed to check
the distance between the nozzle and Heated Print Bed. Rotate the wing nut to raise the Heated Print Bed.The distance
between the Extruder and bed should be 0.1mm or roughly the thickness of an A4 sheet of paper. The paper should
have very slight friction as you move it under the Extruder but should still slide freely.
Step 5：Move the Extruder to each of the other corners and repeat the process. Move the Extruder to the centre
of the Heated Print Bed and test the gap with a sheet of paper. Keep adjusting and testing until the gap is uniform
on all points of the bed.
Step 6：Print a model to check whether the leveling is successful.(Please refer to “sixth.print model” of printing
method)
To Next Page
Loading...
