Assembly of Front Handle.
1. Insert the Front Handle into into the area indicated in
figure A.
2. Secure the Front Handle by tightening the already
located screw, as illustrated in figure B. Repeat for
the other side.
Assembly
A
- before checking, cleaning or working on the product;
- if you hit an object. Do not use your product until you
are sure that the entire product is in a safe operating
condition;
- if the product starts to vibrate abnormally. Check im-
mediately. Excessive vibration can cause injury.
- before passing to another person.
Maintenance and storage
1. Keep all nuts, bolts and screws secure to be sure the
product is in safe working condition.
2. Replace worn or damaged parts for safety.
3. Be careful during adjustment of the product to pre-
vent entrapment of the fingers between moving
blades and fixed parts of the machine.
4. After use the product should be stored using the
blade cover provided.
5. Store in a cool dry place and out of reach of children.
Do not store outdoors.
6. Allow the product to cool for at least 30 minutes be-
fore storing.
Battery
Cordless Battery Powered Products require special care.
1. AVOID ACCIDENTAL STARTING
KEEP HANDS AND FINGERS AWAY FROM THE
SWITCH LE
VER WHILE CARRYING THE PROD-
UCT.
2. Always charge the product indoors and store in a
cool dry place - out of the reach of children.
3. Use the charger with standard domestic household
electrical outlets only.
4. Do not abuse the charger or charger cord.
5. Do not use the charger if the charger or cable is dam-
aged.
6. Do not charge the battery or use the unit in an explo-
sive or corrosive environment. Avoid areas where
flammable liquids or gases are present to avoid cre-
ating a fire or explosion.
7. Do not attempt to repair the unit including the battery.
8. Do not insert any object into the motor area. Keep
free of debris to avoid overheating.
9. Do not incinerate or mutilate the battery. Batteries
contain hazardous chemicals. Dispose of properly.
Battery Pack
Battery Pack Care
1. If over a period of time the Battery Pack quickly runs
down after a full 3 hour charging period, a
replacement Battery Pack is needed.
2. There will be some charge present in the Battery Pack
but to ensure maximum running time, charge your
Battery Pack for 3 hours before first use.
3. To prevent permanent Battery Pack damage, never
store in a discharged condition.
4. Contact your local approved service
centre/dealer/distributor for a replacement Battery
Pack and for safe disposal of your old Battery Pack.
5. Battery
18/24 Volt 1.6 AmpHour "High Power"
Sealed for Life No maintenance required
• IMPORTANT
DISPOSE OF YOUR OLD BATTERY PACK SAFELY
DO NOT CUT OPEN, BURN OR INCINERATE.
Winter Storage
1. Fully charge for 3 hours before winter storage.
2. Re-charge the Battery Pack every 3 to 4 months for a full
3 hour charging period to top up the battery charge dur-
ing winter storage.
3. Avoid extended storage without re-charge.
4. Store in a cool dry place.
For further information on Battery Pack replacement contact
Husqvarna UK Ltd. Customer Service direct:-
Telephone: 0844 844 4558 UK 1800 882 350 ROI Fax:
013
25 302530
B
To Next Page
Loading...
