Wheel Assembly (B1) & (B2)
1. Fix the 2 halves of the wheel together as illustrated in
fig B1.
2. Attach the wheel to the trimmer making sure that it is
located into the groove on the trimmer head (B2).
3. Clip the wheel together on the other side, making sure
it is secure.
4. The wheel should turn freely.
Safety Guard Assembly (C1) & (C2)
1. Locate the safety guard over the cutting head.
Ensure the nylon line is fed through the hole in the
safety guard as illustrated in fig C1.
2. Push into location and turn safety guard in the
direction illustrated in Fig C2, until a click is heard and
the safety guard is securely locked in position.
• ENSURE THE SAFETY GUARD IS SECURELY IN
PLACE BY ATTEMPTING TO TWIST GUARD.
Steady Handle Assembly (D)
1. Depress the two buttons on the sides of the switch
handle.
2. Locate the steady handle over the buttons and
release the buttons.
3. Adjust the steady handle to the most comfortable
operating position by depressing the buttons and
moving the handle.
Height Adjustment (E)
1. Turn height adjuster (E1) in the direction indicated to
un-lock (E2).
2. Adjust the length of the tube to the most comfortable
operating position.
3. Turn height adjuster in the opposite direction to lock
(E3).
• ENSURE THAT THE TUBE IS FULLY SECURED.
Cable Restraint (F1) & (F2) (optional)
1. Form loop in mains cable and push the loop through
the slot as illustrated in picture (F1).
2. To secure, position loop over the hook and pull the
cable back through the slot as illustrated in picture
(F2).
Assembly Instructions cont’
C2
C1
D
B1 B2
Double Auto Feed System
How the automatic line feed works (G)
1. When initially switching on the trimmer, a small length
of line is fed out.
2. A ʻclatteringʼ noise will be heard when the two nylon
lines hit the line cutter. DO NOT BE ALARMED this
is quite normal. After approximately 5 seconds the
line will be cut to the correct length and the noise will
reduce as the motor reaches full speed.
• Make sure the motor is up to full speed before
trimming or edging.
3. If the noise of the nylon line being cut cannot be
heard, more line will need to be fed out.
4. To feed more line, it is first necessary to to allow the
motor to stop completely, then re-start, allowing the
motor to reach full speed.
5. Repeat step 4. until you hear the lines hitting against the
cutter. (Do not repeat this procedure more than 6 times)
6. If problems are experienced with the automatic line
feed refer to Fault Finding Chart.
G
line cutter
F1 F2
E
1
3
2
1
2
CLICK!
To Next Page
Loading...
