EN Electric Hedge Trimmer
1. SAFETY ...............................................4
2. INITIAL OPERATION ......................................5
3. OPERATION ............................................6
4. MAINTENANCE .........................................6
5. STORAGE .............................................6
6. TROUBLESHOOTING ....................................6
7. TECHNICAL DATA .......................................7
8. SERVICE / WARRANTY .................................... 7
Original instructions.
This product is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the product by a per-
sonresponsible for their safety. Children should be supervised to ensure
that they do not play with the product. The use of this product by young
people under the age of 16 is not recommended.
Intended use:
The FLYMO Hedge Trimmer is intended to cut hedges, shrubs and grass
coverings in private domestic gardens and allotments.
The product is not intended for long term use.
DANGER! Risk of injury!
v Do not use the product to cut lawns / lawn edges, to chop up
material or to make compost.
Carton Contents:
1
Mains cable
2
Handguard
3
Blade cover
4
Operator’s manual
IMPORTANT!
Please check if the contents of the carton are correct BEFORE
assembling your new product.
IF ANY PARTS ARE MISSING CONTACT:
Husqvarna UK Ltd. Customer Service Department direct
Telephone: 0344 844 4558 UK 1800 882 350 ROI
Fax: 01325 302530
1. SAFETY
Important! Read the operator’s manual carefully before use and keep
for future reference.
If not used properly this product can be dangerous. The warnings and
safety instructions must be followed to ensure reasonable safety and
efficiency in using this product. The operator is responsible for following
the warnings and instructions in this manual and on the product. Never
use the product unless the guards provided by the manufacturer are in
the correct position.
Symbols on the product:
Read operator’s manual.
Wear safety glasses and ear protection.
Danger – Keep hands away from blade.
Do not let the product become wet with rain or other moisture.
Do not leave the product outdoors while it is raining.
Disconnect the mains cable if the cable becomes damaged
or cut.
General safety warnings
Cables
If extension cables are used, these must comply with the minimum cross-
sections in the table below:
Voltage Cable length Cross section
220 – 240 V / 50 Hz Up to 40 m 1.0 mm²
220 – 240 V / 50 Hz Up to 60 m 1.5 mm²
220 – 240 V / 50 Hz Up to 100 m 2.5 mm²
Minimum rating: 1.0 mm² size cable, 10 amps 250 volts AC.
Your product is supplied with cable wired directly into the product.
1. If the supply cord is damaged, it must be replaced by your local
Husqvarna UK Ltd. Approved Service Centre or similarly qualified
persons in order to avoid a hazard.
2. Flymo Extension Cables are available from your local Husqvarna UK Ltd.
Approved Service Centre.
3. Do not wire an extension cable directly to your product yourself. Please
contact your local Husqvarna UK Ltd. Approved Service Centre for further
information on the connectors and kits available.
4. Only use extension cables specifically designed for outdoor use and
which conform to one of the following specifications:
Ordinary rubber (60245 IEC 53), Ordinary PVC (60227 IEC 53) or
Ordinary PCP (60245 IEC 57).
5. Use only permitted extension cables as per HD516.
v Ask your electrical specialist.
General Power Tool Safety Warnings
WARNING! Read all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow the warnings and instructions may result in electric
shock, fire and / or serious injury.
Save all warnings and instructions for future reference.
The term “power tool” in the warnings refers to your mains operated (corded)
power tool or battery operated (cordless) power tool.
1) Work area safety
a) Keep work area clean and well lit. Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmospheres, such as in the
presence of flammable liquids, gases or dust.
Power tools create sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while operating a power tool.
Distractions can cause you to lose control.
2) Electrical safety
a) Power tool plugs must match the outlet. Never modify the plug in any
way. Do not use any adaptor plugs with earthed (grounded) power tools.
Unmodified plugs and matching outlets will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded surfaces, such as
pipes, radiators, ranges and refrigerators. There is an increased risk of
electric shock if your body is earthed or grounded.
c) Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of electric shock.
d) Do not abuse the cord. Never use the cord for carrying, pulling or
unplugging the power tool. Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords increase the risk of electric shock.
e) When operating a power tool outdoors, use an extension cord
suitable for outdoor use.
Use of a cord suitable for outdoor use reduces the risk of electric shock.
f) If operating a power tool in a damp location is unavoidable, use
aresidual current device (RCD) protected supply.
Use of an RCD reduces the risk of electric shock.
3) Personal safety
a) Stay alert, watch what you are doing and use common sense when
operating a power tool. Do not use a power tool while you are tired
or under the influence of drugs, alcohol or medication. A moment of inat-
tention while operating power tools may result in serious personal injury.
b) Use personal protective equipment. Always wear eye protection.
Protective equipment such as dust mask, non-skid safety shoes, hard hat,
or hearing protection used for appropriate conditions will reduce personal injuries.
c) Prevent unintentional starting. Ensure the switch is in the OFF-posi-
tion before connecting to power source and / or battery pack, picking
up or carrying the tool. Carrying power tools with your finger on the switch or
energising power tools that have the switch on invites accidents.
d) Remove any adjusting key or wrench before turning the power tool
on. A wrench or a key left attached to a rotating part of the power tools may
result in personal injury.
e) Do not overreach. Keep proper footing and balance at all times.
This enables better control of the power tool in unexpected situations.
f) Dress properly. Do not wear loose clothing or jewellery. Keep your
hair, clothing and gloves away from moving parts.
Loose clothes, jewellery or long hair can be caught in moving parts.
g) If devices are provided for the connection of dust extraction and
collection facilities, ensure these are connected and properly used.
Use of dust collection can reduce dust-related hazards.
4
Page 2 width 2 mm less: 208 mm
31460-85.960.01.indd 431460-85.960.01.indd 4 07.09.21 11:0507.09.21 11:05
To Next Page
Loading...
