9
(GB)
MAINTENANCE
Guarantee, Fault Finding Hints, Service Recommendations
Guarantee and Guarantee Policy
If any part is found to be defective due to
faulty manufacture within one year of original
purchase, Electrolux Outdoor Products,
through its Authorised Service Repairers will
effect the repair or replacement to the
customer free of charge providing:
(a) The fault is reported directly to the
Authorised Repairer.
(b) Proof of purchase is provided.
(c) The fault is not caused by misuse,
neglect or faulty adjustment by the user.
(d) The failure has not occurred through fair
wear and tear.
(e) The machine has not been serviced or
repaired, taken apart or tampered with by
any person not authorised by Electrolux
Outdoor Products.
(f) The machine has not been used for hire.
(g) The machine is owned by the original
purchaser.
(h) The machine has not been used outside
of the country for which it was specified.
(i) The machine has not been used
commercially.
* This guarantee is additional to, and in no
way diminishes the customers statutory
rights.
Failures due to the following are not
covered, therefore it is important that you
read the instructions contained in this
Operator's Manual and understand how to
operate and maintain your machine:
Failures not covered by guarantee
* Replacing worn or damaged blades
* Failures as a result of not reporting an
initial fault.
* Failures as a result of sudden impact.
* Failures as a result of not using the
product in accordance with the
instructions and recommendations
contained in this Operator's Manual.
* Machines used for hire are not covered
by this guarantee.
* The following items listed are considered
as wearing parts and their life is
dependent on regular maintenance and
are, therefore not normally subject to a
valid warranty claim: Blades, drive belts.
* Caution!
Electrolux Outdoor Products does not
accept liability under the warranty for
defects caused in whole or part, directly or
indirectly by the fitting of replacement parts
or additional parts that are not either
manufactured or approved by Electrolux
Outdoor Products, or by the machine
having been modified in any way.
Fault Finding Hints
Engine Will Not Start
1. Ensure that the Operator Presence Control is
gripped firmly to the upper handle.
2. Check that there is sufficient fuel of the correct
mix in the fuel tank.
3. The engine may have flooded. Remove and dry
the spark plug.
4. Fuel mixture may be incorrect or stale - if so -
replace with fresh mixture.
5. Check that the blade bolt is tight. A loose blade
bolt could cause difficult starting.
6. If the engine will still not start - disconnect
the spark plug lead and consult your local
approved Electrolux Outdoor Products
Service Centre/Dealer.
Poor Flotation or Lack of Power
1. Disconnect the spark plug lead.
2. Clean the underside of the hood, the air filter,
the fan, around the engine and the air intakes.
3. Fuel mixture may be incorrect or stale - if so -
replace with fresh mixture.
4. If poor flotation or lack of power persists -
disconnect the spark plug lead and consult
your local approved Electrolux Outdoor
Products Service Centre/Dealer.
Excessive Vibration
1. Disconnect the spark plug lead.
2. Check that the blade is correctly fitted. See '
Fitting and Removing the Blade and Fan'.
3. If the blade is damaged or worn replace it with a
new one.
4. If vibration persists - do not use - disconnect
the spark plug lead and consult your local
approved Electrolux Outdoor Products
Service Centre/Dealer.
Service Recommendations
We strongly recommend that your
product is serviced at least every
twelve months, more often in a
professional application.
To Next Page
Loading...
