How to Trim
WARNING: The use of eye protection is recom-
mended. Do not lean over the trimmer guard whilst
trimming, objects may be thrown by the cutting line.
Do not allow cutting head to rest on the ground. Do
not overload your trimmer. Overloading can be
avoided by making sure the motor speed does not
drop unduly. Disconnect the mains electricity sup-
ply before attempting any maintenance or adjust-
ment.
1. Cut with cutting line at an angle using the tip
(F).
2. Swing trimmer in and out of the cutting area
taking small cuts (F).
F
Line cutter
G
Manual Line Feed System
To feed the nylon line
1. Press and hold the two latches (G).
2. Gently pull the line until it reaches the line cut-
ter.
3. Release the two latches. Check that the spool
is locked in position.
4. If too much line has been fed out, press the two
latches and turn the spool anti-clockwise until
the line is at the desired length.
Starting and Stopping
E
WARNING
Cutting head continues to rotate after the trimmer
has been switched off.
To start your trimmer
Squeeze the switch lever (E).
To stop your trimmer
Release the switch lever (E).
To Next Page
Loading...
