Fault Finding Chart
WARNING Disconnect from the mains electricity supply before attempting any mainte-
nance or adjustment.
FAULT CHECK ACTION
Is the line fed out and visi-
ble?
Remove cap and spool, free
line and re-fit spool and cap.
The line may be jammed on the
spool. Rewind line to remove
crossed loops.
Check that line is in correct
section of spool.
Is the manual line feed work-
ing?
Has too much line been fed
out?
Rewind line.
Contact your local approved Serv-
ice Centre or Husqvarna UK Ltd.
Customer Service.
Is the line cutter missing from
the safety guard?
Contact Husqvarna UK Ltd. Customer Service
Telephone : 0844 844 4558 UK 1800 882 350 ROI
No
No
Ye s
Ye s
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS
CLATTERING NOISE
LINE SNAPS CONTINU-
OUSLY
IF NONE OF THE ABOVE
OR IF FAULT PERSISTS
Has the motor reached full
speed before use?
No
Allow the motor to reach full
speed before use
Are you using the trimmer
correctly
?
?
Only use tip of nylon line to
trim.
Is the line jamming on the
spool?
Ye s
Rewind the line on the spool, if
symptoms still persist, change
spool and line.
Replacement Parts
Spool and Line
Reference no.: FLY031
Part no.: 513106090
Maintenance
After you have finished using your trimmer follow
the procedure below:
1. Disconnect from the mains electricity supply.
2. Never clean your trimmer with water, cleaning
fluids, or solvents, just remove debris with a
suitable tool, a soft brush or dry cloth.
3. Using a soft brush, clean around the inside of
the safety guard, the cutting head and the
motor housing air vents. (Fig L, M).
4. Inspect the trimmer carefully, especially the
parts of the cutting head.
5. If your trimmer is damaged in any way contact
your local approved service centre.
• Never use a damaged trimmer.
6. Wind cable carefully to avoid kinking.
7. Store in a cool, dry place and out of reach of
children.
L
M
To Next Page
Loading...
