Maintenance
X2
X1
• WARNING
Cutting head continues to rotate after the trimmer
has been switched off. Keep fingers and hands
clear of the line cutter on leading edge of guard.
Caring for your product
After you have finished using your product follow the
procedure below:
1. Never clean your trimmer with water, cleaning flu-
ids, or solvents, just remove debris with a suitable
tool, a soft brush or dry cloth.
2. Using a soft brush, clean around the inside of the
safety guard, the cutting head (X1) and the motor
housing air vents. (X2)
3. Remove the wheel by pressing one of the buttons.
Clean the wheel and groove on trimmer head with a
soft brush (X3 & X4).
4. Attach wheel as described in Wheel Assembly.
5. Inspect the product carefully, especially the parts of
the cutting head.
6. If your product is damaged in any way contact your
local Husqvarna UK Ltd. approved service centre.
• Never use a damaged product.
Storing your product
1. Attach the Steady Handle Storage Holder to the
wall with the two screws provided (Y1)
2. Store the Steady Handle in the holder as illustrated
in Fig Y2
3. Attach the Trimmer Head Storage Holder to the wall
with the two screws provided (Z1)
4. Store the Trimmer Head in the holder as illustrated
in Fig Z2
• Store in a cool, dry place and out of reach of chil-
dren. Do not store outdoors.
X4
X3
Y1
Z1
Y2
Z2
To Next Page
Loading...
Need help?
General