Flymo Scirocco 3000 Original Instructions

Fails To Operate
1. Is the power turned on?
2. Check access screw is fully tightened.
3. Check the fuse in the plug, if blown replace.
4. Fuse continues to blow?
Immediately disconnect from the mains electricity sup-
ply and consult your local Approved Service Centre
Poor Blowing
1. The air inlets are blocked, clean all air inlets.
2. Mode indicator not in the right position?
3. Tube may be blocked. Open Blockage Clearing Cap and
clear blockage with blunt edge instrument
3. If poor blowing persists?
Immediately disconnect from the mains electricity sup-
ply and consult your local Approved Service Centre
Poor Vacuum
1. The air inlets are blocked, clean all air inlets.
2. Mode indicator not in the right position?
3. If poor vacuuming persists?
Immediately disconnect from the mains electricity sup-
ply and consult your local Approved Service Centr
e
Excessive Vibration
1. Inspect the fan for damage and replace if necessary
2. If excessive vibration persists?
Immediately disconnect from the mains electricity sup-
ply and consult your local Approved Service Centre
Fault Finding Hints
WARNING Never use water for cleaning your
product, use only a dry cloth. Do not clean with
chemicals or solvents, some can destroy critical
plastic parts.
After Using Your Product
1. Switch off and disconnect from the mains elec-
tricity supply before cleaning your product.
2. Always empty the debris bag.
3. Unscrew the Access Screw (S1) until the motor
housing unit pivots open.
4. Inspect the fan for damage and replace if nec-
essary. Clean the fan with a soft brush ensur-
ing it is free from debris (S2)
5. Clean the tube with a soft brush.(S3)
6. Clean the debris exit hole with a soft brush.
(S4)
7. Close up the motor housing unit and tighten
the Access screw until secure (do not over-
tighten).
8. Clean the air vents with a soft brush (S5)
9. Turn over the product and clean the Debris
Outlet with a soft brush.(S6)
10. Refit the debris bag.
Storing
Your Pr
oduct
Always store the product in a dry place ensuring the
cable is not likely to be damaged on sharp edges etc.
IMPORTANT - ACCESS SCREW - WHEN STORING
PRODUCT:
Always ensure Access Screw (S1) is unscrewed back
from the switching position by approximately 3 full
turns prior to storage.
Be careful to ensure the motor housing does not pivot
open.
Remember to tigthen Access Screw before re-using
the product.
S2
S3
S4
S6
Caring for your product
S1
S5
S1
3 turns

Flymo Scirocco 3000 Specifications

General

Power	3000 W
Cable Length	10 m
Blower Function	Yes
Vacuum Function	Yes
Mulching Ratio	10:1
Suction Capacity	14 m³/min
Collection Bag Volume	45 L