EasyManuals Logo

Flymo Scirocco 3000 User Manual

Flymo Scirocco 3000
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
f) Never attempt to override the interlocked feature of the
guard.
5 Additional safety instructions for units with
bagging attachments
Switch-off the machine before attaching or removing the
bag.
Additional safety warnings
Electrical safety
DANGER! Cardiac arrest!
This product makes an electromagnetic field while
it operates. This field may under some conditions
interfere with active or passive medical implants.
To decrease the risk of conditions that can possibly
injure or kill, we recommend persons with medical
implants to speak with their physician and the med-
ical implant manufacturer before you operate the
product.
Before use, examine the cable for signs of damage or
ageing. If the cable is found to be defective, take the
product to an authorised Service Centre and have the
cable replaced.
Do not use the product if the electric cables are damaged
or worn.
Immediately disconnect from the mains if the cable is cut,
or the insulation is damaged. Do not touch the electric
cable until the cable has been disconnected. Do not
repair a cut or damaged cable. Replace it with a new one.
The extension cable must be uncoiled. Coiled cables can
overheat and reduce the efficiency of your mower. Keep
the extension cable away from product, always work
away from the power point.
Do not pull cable around sharp objects.
Always switch off at the mains before disconnecting any
plug, cable connector or extension cable.
Stop the engine, disconnect the mains and examine the
cable for damage or ageing before you wind the cable for
storage.
Do not repair a damaged cable, replace it with a new one.
Use only genuine replacement cable.
Always wind the cable carefully, avoid kinking.
Do not carry the product by the cable.
Do not pull on the cable to disconnect any of the plugs.
Use only on AC mains supply voltage shown on the prod-
uct rating label.
Our products are double insulated to EN 60335. Do not
connect an earth to any part of the product.
Check the working area for hidden cables.
Do not use for pond care or close to water.
Only use a weather proof extension cable fitted with
a coupler according to IEC 60320-2-3.
Personal safety
DANGER! Risk of suffocation!
Small parts can be easily swallowed. There is also
a risk that the polybag can suffocate toddlers. Keep
toddlers away when you assemble the product.
Do not use in explosive atmosphere.
Never operate the product when you are tired, ill or under
the influence of alcohol, drugs or medicine.
Do not overload the product.
Use gloves, wear slip resistant shoes and wear eye pro-
tection.
Do not use under wet conditions.
Do not disassemble the product further than the delivery
status.
Operate the appliance only in daylight or in good artificial
light.
Walk, never run.
Keep all nuts, bolts and screws tight to be sure the appli-
ance is in safe working condition.
Avoid using the machine in bad weather conditions espe-
cially when there is a risk of lightning.
2. ASSEMBLY
DANGER! Risk of injury!
Cut injury when the rotor blades turn or
the product starts accidentally.
v Disconnect the product from the mains and wait
for the rotor blades to stop before you assemble
the product.
DANGER! Cut injury!
v Assemble the product completely before you
use the product in blower or vacuum mode.
To close the blockage clearing cap [ Fig. A1 ]:
v Close the blockage clearing cap.
Make sure it is secure.
To assemble the suction tube [ Fig. B1 / B2]:
IMPORTANT: When the Suction Tube is locked into
the operating position, this is a permanent fixture.
The Suction tube cannot be pushed back to its pack-
aged position.
1. Extend the lower suction tube to its full length.
2. Turn the lower suction tube anti-clockwise in the
direction of the arrow, approximately 1.5 times, until
it locks into position.
To assemble the debris outlet [ Fig. C ]:
v Fit the Debris Outlet to the underside of the product,
until it locks into position.
To assemble the additional handle [ Fig. D ]:
1. Depress the two buttons on the sides of the switch
handle.
EN
6
GBV3000-20.960.01.indb 6 28.07.17 12:51

Other manuals for Flymo Scirocco 3000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Flymo Scirocco 3000 and is the answer not in the manual?

Flymo Scirocco 3000 Specifications

General IconGeneral
BrandFlymo
ModelScirocco 3000
CategoryBlower
LanguageEnglish

Related product manuals