9
Fault Finding Chart
FAULT CHECK ACTION
Unit fails to
operate.
1. Switch in the OFF position.
2. Mains cable disconnect ed
from electric ity supply.
3. Circuit breaker tripped, or
fuse blown.
4. Mechanical failure.
1.Slideswitchto
ON position.
2. Reconnect cable.
3. Reset circuit breaker or
fuse.
4. Contact your local Electrolux
Outdoor Products Approved
Service Centre.
Unit
vibrates
abnormally.
1. Debris hung on impeller.
2. Mechanical failure.
1. Clean unit. Remove any
debris .
2. Contact your local Electrolux
Outdoor Products Approved
Service Centre.
Impeller
will not turn
freely.
1. Debris in air intake area or
hung on impeller.
2. Mechanical failure.
1. Clean unit. Remove any
debris.
2. Contact your local Electrolux
Outdoor Products Approved
Service Centre.
WARNING: Always stop the unit and disconnect the mains electricity sup-
ply before pe rforming all of the recommended remedies be low except reme-
dies that require unit to be operating.
Environmental Information
Electrolux Outdoor Products are manufactured under an Environmental Manage-
ment System (ISO 14001) using,where practical,components manufactured in the
most environmentally responsible manner, acc ording to c ompany procedures,and
with the potential for recycling at the end of the products’ life. Packag ing is recy-
clable and plastic components have been labelled (where practic al) for catego-
rised recycling.
S Awareness of the env ironment must be considered when disposing of
‘end--of--life’ product.
S If necessary, contact your local authority for disposal information.
Service Recomme ndations
S Your product is u niquely identified by a product rating label.
S We strongly recommend that your product is serviced at least every twelve
months.