Y
X1
X3
X2
Z
Cleaning the Easi-Reel cable winder
1. Lift grassbox lid, squeeze together the two
catches (X1) and remove the cable winder.
2. Clean the cable winder and the area it was lo-
cated with a soft brush (X2 & X3)
3. Replace the cable winder, ensuring it clicks into place.
At the End of the Mowing Season
1. Replace blade, bolts, nuts or screws, if necessary.
2. Clean your lawnmower thoroughly.
3. Ask your local Service Centre to clean the air filter thor-
oughly and carry out any service or repairs required.
4. Make sure that the electric cable is wound properly.
Transporting and Storing the lawnmower
The handles can be folded to take up the minimum
of space (Y)
• Loosen the handle knobs.
• Fold the upper handle over the lawnmower.
• Ensure the switchbox cable is not trapped.
• The Vision Compact lawnmower may be trans-
ported on its roller (Z)
• Store in a dry place where your lawnmower is pro-
tected from damage.
Fails to Operate
1. Is the correct Starting procedure being followed?
See ‘To Start your Lawnmower’
2. Is the Power Turned On?
3. Check the fuse in the plug, if blown replace.
4. Fuse continues to blow?
Immediately disconnect from the mains electricity supply
and consult your local approved Service Centre.
Poor Flotation
1. Disconnect from the mains electricity supply.
2. Clean the underside of the hood and the fan blades.
3. Raise to a higher height of cut. See ‘Adjusting the
Cutting Height’.
4. If poor flotation persists?
Disconnect from the mains electricity supply and con-
sult your local approved Service Centre.
Poor Collection
1. Is the grassbox lid firmly closed?
2. Is the grassbox fitted correctly?
3. Are you mowing correctly?
4. Check all air vents and openings are not obstructed.
5. Raise to a higher height of cut. See ‘Adjusting the
Cutting Height’.
6. If poor collection persists.
Disconnect from the mains electricity supply and con-
sult your local approved Service Centre.
Excessive Vibration
1. Disconnect from the mains electricity supply.
2. Check that the blade is fitted correctly?
3. If the blade is damaged or worn, replace it with a new one.
4. If vibration persists?
Immediately disconnect from the mains electricity supply and
consult your local approved Service Centr
e.
Fault Finding Hints
Replacement Parts
Blade
330 Reference no.: FLY 007
350 Reference no.: FLY 008
380 Reference no.: FLY 009
Part no.: 511835790
Part no.: 512733490
Part no.: 511843690
To Next Page
Loading...
