FlySky FMS-R3A - User Manual

FMS-R3A
接收机 Receiver
http://www.flysky-cn.com
Copyright ©2022 Flysky Technology co., ltd
接收机概览
Overview
[1] Motor interface
[2] Battery line
[3] Power Switch
[4] Antenna
[5] LED
[6] CH3
[7] CH1
[8] Car light interface
产品规格
Product specication
对码
Binding
Product Model: FMS-R3A
Compatible Transmitters: FMS-G3
Model Type:
1:18 , 1:24 simulation cars or rock cars
PWM Channels: 3
Number of car light interfaces：1
RF: 2.4GHz ISM
2.4G Protocol: AFHDS 2A-BS
Maximum Power: 20dBm (e.i.r.p.) （EU）
Resolution: 1024
Antenna: Single External Antenna
Input Power: 2S Lipo batteries
Continuous/Peak Current: 10A/40A
Data Output: PWM
BEC Output: 5V/1A
Distance: >100m (Ground distance without interference)
Temperature Range: -10℃ ~ +60℃
Humidity Limit: 20% ~ 95%
WaterProof: PPX4
Online Update: No
Dimensions: 32mm*24.4mm*12mm
Weight: 8g
Certi󽗉cations: CE，FCC ID: 2A2UNR3A00
The receiver automatically enters the binding state once it is powered on.
Follow the steps below to bind with the receiver:
1.Putthetransmitterintobindingstate,refertothemanualofthetransmitter.
2.Putthereceiverintobindingmodebypoweringonthereceiver,thereceiverLED󽗊ashqucikly.
3.Thebindingprocessis󽗉nishedwhenthetransmitterLEDstops󽗊ashingandissolidon.
4.Checktomakesurethetransmitterandreceiverareworkingcorrectly,ifthereareanyissuesorunexpectedoperationarise,
followthestepsabovetobindagain.
Notes:
1. If the transmitter disconnects with the receiver, the transmitter LED will go into three-󽗊ash-one-o󽗈 state.
2. Set the transmitter to its binding state 󽗉rst, and then set the receiver to its binding state. If the binding is not 󽗉nished
within 10s, the LED of the receiver will enter its slow 󽗊ashing state.

FlySky FMS-R3A Specifications