FMS-R3A
接收机 Receiver
http://www.flysky-cn.com
Copyright ©2022 Flysky Technology co., ltd
Attention:
• Make sure the product is installed and calibrated correctly, failure to do so may result in serious injury.
• Please carefully check each power device and car frame instructions to ensure the power matching is reasonable before use. Avoid damaging power system due
to incorrect matching.
• Do not let the external temperature of the system exceed 90℃ /194 ℉ , because high temperature will damage the power system.
• Make sure the receiver's battery is disconnected before turning o the transmitter, failure to do so can result out of control. Unreasonable setting of the Failsafe
may cause accidents.
• After use, remember to disconnect the battery and the ESC. If the battery isn't disconnected, the ESC will consume electric energy all the time even if it is o. It will
discharge completely if connect the battery for a long time, thus resulting in the failure of the battery or the ESC. We are not responsible for any damage caused by
this!
• Make sure the receiver is mounted away from motors or any device that emits excessive electrical noise.
• Keep the antenna of the receiver at least 1cm away from conductive materials such as carbon or metal.
• Do not power on the receiver during the setup process to prevent loss of control.
保护功能
protection
When the receiver voltage is lower than 6.4V, all channels have no output.
To Next Page
