http://www.ysky-cn.com
Copyright ©2024 Flysky Technology Co., Ltd.
FS-GR3E
接收机 Receiver
Attention:
• Make sure the product is installed and calibrated correctly, failure to do so may result in serious injury.
• Make sure the receiver's battery is disconnected before turning o the transmitter, failure to do so can result out of
control. Unreasonable setting of the Failsafe may cause accidents.
• Make sure the receiver is mounted away from motors, electronic speed controllers or any device that emits excessive
electrical noise.
• Keep the receiver's antenna at least 1cm away from conductive materials such as carbon or metal.
• Do not power on the receiver during the setup process to prevent loss of control.
Binding
Failsafe
Follow the steps below to bind.
1. Put the transmitter into binding state.
2. Plug the binding cable into the BIND/CH3
interface of the receiver,
3. Connect the receiver battery to VCC port of the
receiver, refer to the left diagram. At the same
time, the receiver SIGNAL LED ashes quickly,
indicating that it has entered the binding state.
4. The receiver SIGNAL LED is solid on, indicating
the binding is successful.
5. Power o both the transmitter and the receiver,
and unplug the binding cable from the receiver.
6. Repower both the transmitter and the receiver.
7. Check to make sure the transmitter and
receiver functions are working correctly, repeat
steps 1 to 6 (binding process) if any problems
arise.
The receiver supports failsafe setting. The fail-safe function is used when the receiver loses signal and is out -of
-control. The receiver performs channel output according to the set fail-safe value to protect the safety of the model
and personnel. This function is only for throttle channel.
Follow the following to set.
When the transmitter and receiver are in normal communication, pull/push the throttle trigger to the desired position,
then hold the trigger, at the same time, press the FAIL SAFE KEY of the receiver. The receiver SIGNAL LED will be ashing
and stop after 3 seconds around, which means setting nished.
Then follow the following to verify whether the setting is as your desired.
The transmitter and receiver are in normal communication, then power o the transmitter, the throttle channel will
automatically output the value according to the failsafe setting.
SIGNAL LED
Binding cable
Receiver
Battery
To Next Page
Loading...
