16
5. Launch preparations
5.1. Laying out the kite
Unfold and lay out the kite, trailing edge facing the wind for a launch from the power-
zone, or with the wingtip facing upwind for a launch from the edge of the wind
window. Weigh down the kite with sand (if available; if not, any none piercing or blunt
objects).
Now unwind the flying-lines from the bar in a 90° angle to the kite. Finally check all of
the kite’s lines, pulleys and Safety-Systems for tangles, knots, sand blocking or
previously sustained damage.
5.2. Pre-inflation
It is not essential to pre-inflate the new kites. However a thorough pre-inflation gives
you maximum control over the kite and helps in light wind starts.
There are many ways to pre-inflate a FS kite. The EXTACY/PSYCHO² have new
valve straps, which make it even easier to pre-inflate. The kite should remain calm,
so that the pulleys don’t tangle up with the bridle lines. The ROOKIE² has many
openings, so it is full as soon as you launch. Pre-inflation is therefore not necessary.
5.3. Connecting the safety
Attach the KITE-LEASH onto the harness spreader-bar. Make sure that the plastic
clip is free of sand and has engaged properly to avoid unwanted release. You should
be able to hear the clip lock in; otherwise optimal safety can’t be ensured.
To Next Page
Loading...