4
CE Warning
DoC Declaration
FCC Statement
Environmentally friendly disposal
RF Exposure Statement
The ce warns that the installation of the antenna used in this transmitter must be kept in distance from all the person-
nel and shall not be used or used with any other transmitter. The end user and the installer must provide antenna
installation instructions and transmitter operating conditions to meet the requirements for rf exposure compliance.
Hereby, [ShenZhen FLYSKY Technology Co., Ltd.] declares that the Radio Equipment
[FS-FMS-MG6-BS&FS-FMS-R6D-ESC-BS] is in compliance with RED 2014/53/EU.
The full text of the EU DoC is available at the following internet address: www.flyskytech.com/info_detail/10.html
Old electrical appliances must not be disposed of together with the residual waste, but have to be disposed of sepa-
rately. The disposal at the communal collecting point via private persons is for free. The owner of old appliances is
responsible to bring the appliances to these collecting points or to similar collection points. With this little personal
effort, you contribute to recycle valuable raw materials and the treatment of toxic substances.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
CAUTION
Risk of explosion if the battery is replaced an incorrect disposal of a battery into fire or a hot oven, or mechanically
crushing or cutting of a battery, that can result in an explosion; leaving a battery in an extremely high temperature
surrounding environment that can result in an explosion or the leakage of flammable liquid or gas; battery subjected to
extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or televison reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equip-
ment. Such modifications could void the user authority to operate the equipment.
1. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-lacated or operating in conjunction with any other transmitter.End-users and installers must
be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure com-
pliance.
2.Move all your channels to the desired position.
3.Select [All channels] and then [Yes] in the confirmation box.
Certifications
认证相关
To Next Page
Loading...
