24
Vehicle Setup
车辆设置
Connecting the battery
连接电池
Step 1: With the bottom of the vehicle facing up, release the four buckles (opened inward) indicated by the arrows to
separate the car shell from the chassis.
Step 2: Place the battery in the battery compartment on the frame and fix it with the attached silicone rubber band.
Connect the battery plug to the female end of receiver/ESC (2-in-1) unit.
Step 3: Lock the four buckles to fix the car shell in place.
Caution: Do not crush or damage the wiring when attaching the car shell to the chassis.
NOTE
1. If it is not in use for a long time, unplug and take off the battery to prevent battery leakage.
2. Do not open, disassemble, or attempt to repair the battery.
3. The battery needs to be disconnected from vehicle before it can be charged
4. Do not charge battery in vehicle.
步骤1：如图所示，翻转模型车使之底部朝上，将箭头所示的四个卡扣分别向内掰打开，分离车壳和车架。
步骤2：在图示电池舱位置放入电池，并使用所附硅胶轧带固定。连接电池插头至接收机/电调二合一装置的母头。
步骤3：锁紧卡扣固定车壳。
注意：固锁车壳时切勿挤压电线。
注意：
1、如果长时间不用，请拔下电池，以防电池损坏。
2、不要打开、拆解或试图维修电池。
3、在给电池充电之前，需要先断开电池与车辆的连接。
4、请勿在车内给电池充电。
2
3
1
To Next Page
Loading...
