8
fig. 9
fig. 8
1cm/0.45“
You can now start the connection phase – i.e. connection of the audio signal (RCA), REMOTE, and loudspeaker
cables. Connect the RCAs to the amplifier (see fig. 10), making sure that the polarities are correct (i.e. INPUT
Left = black or white, INPUT Right = red). Connect the other end of the RCAs to the car radio’s RCA* outputs
(Left = left ; Right = right).
If the car radio only has speakers output, you must use the high-level adaptator supplied in
the packaging (see fig. 11).
fig. 10
fig. 11
ACCESS SOLUTION 25 A1
User Manual
notice solution 25 a1.indd 8notice solution 25 a1.indd 8 13/02/07 17:40:0713/02/07 17:40:07
To Next Page
Loading...
