EASY
A
User
manual
•
Linking loudspeakers/Hub:
The
loudspeakers
and the Hub have been
linked
at Focal
prior
to
carrying
out
the
final
test
on
your
system. The Hub
can only
be
linked to a
maximum
of 2 speakers.
In
the event
that
the
link
between the
Hub
and one
or
two
speakers
is lost, you can
re-link
the Hub
with
one
or
two
speakers as follows:
How
to
link
the Hub to one
or
two
Easya speakers:
1.
Select an
input
on
the Hub
other
than
the aptX®
Bluetooth®
one.
2.
Press the linked
button
located on the
rear
panel
of the
speaker
button
for
3
seconds.
The LED next to the linked
button
will
flash rapidly
[many
times
per
second).
3.
Press
the
linked
button
at the
rear
of the Hub
for
3 seconds. The LED next to the
linked
button
will
flash rapidly
[many
times
per
second).
Please note: The speakers and the Hub are
linked
when
all
the LEOs [speakers and Hub) begin to
simultaneously
flash
slowly.
Auto Standby:
If
there
is no audio
signal
detected
from
the
Hub
input
for
3
minutes,
the 2
speakers
and
the
Hub
will
move to standby
mode. The Hub LED and
speakers
will
light
up in red. Once an audio
signal
is detected on
the
last
input
selected, the
system
will
be
reactivated. The Hub
will
provide the
musical
signal
to the
speakers
after
a few seconds, the LEOs on
the Hub and speakers
will
light
up in
white
.
Cables
not included:
Analogue
inputs:
• Analogue
1:
3.5mm
mate
mini
jack
• Analogue
2:
2 x
RCA
mate
audio
[right
red,
left
white)
Digital
inputs:
•
Digital
1:
Coaxial
[SPDIF)
digital
Audio RCA
male
[75
Ohms
impedance
recommended
for
24
bits/
96
kHz broadband)
•
Digital
2:
Optical (Toslink)
mate
audio
•
USB: Mate Min
USB-8
To Next Page
Loading...
Need help?
General
Weight and Dimensions
