FPX
PREMIUM AMPLIFIER
User
manual
a
3.3.2-
Locate the negative[-] power cable. This cable should be
as
short
as
possible and ideally should not exceed
1
meter
in
length,
in
order
to
ensure
an optimal connection between the amplifier and the vehicle
chassis
. The cable
and its gauge must
be
in
accordance with the table
in
3.1
. Locate an appropriate ground [earth] point, then sand
it
to
remove all
traces
of
paint or other finish,
thus
optimising the quality
of
the connection. Drill through the
sheet
metal
you
have previously sanded, making a hole to match the bolt
you
have chosen, ensuring
you
are well clear
of
all cable
routes, reservoirs or tanks or other sensitive vehicle parts. Solder and insulate [using heat shrink sleeving] the earth
cable
to
the
FPX
amplifier earth connector supplied
{Fig.
2).
fig.
2
3.4-
Connecting input connectors to your FPX amplifier
You
may now begin the input/output cable connection phase.
Connect
the
RCA
connectors
{Fig.
3),
paying attention
to
polarity and distribution.
Connect
the other end
to
the
amplifier's
INPUTS
connection panel.
fig.
3
To Next Page
Loading...
