SNAPSHOTS - SAVING LIQUID MIX SETTINGS
Liquid Mix has the ability to save and load settings. This means that a successful combination of compressor
and EQ, constructed for vocals for instance, can be recalled at any point and used on another track. Saving
and Loading can be done from the hardware or software, although if saving from the hardware, make sure
the snapshot is renamed from the software using the method below.
To save a snaphot from the software, click on the disk image in the top right of the software window then
select Save a Snapshot from the drop down list. This will save as a .lss file in any location on the computer.
It is advisable to save this file in the following location:
Mac HD – Library – Application Support – LiquidMix
This way, the snapshot can be recalled from the hardware by pressing the Load Snaphot button. Doing
so brings up a list of all snapshots in the folder listed above. Use the data encoder to select one from the list
or press Go Back to cancel. To load a snapshot from the software, simply click on the disk and select Load
Snaphot from the list then navigate to the file on your computer.
There is also an option to Rename a snapshot, essential if saving snapshots from the hardware,
where naming snapshots isn’t possible. To rename a snapshot, click on the disk image in the top right of
the software window, select Rename Snapshot, then click on the Snapshot box, type in a new name and
press enter.
To Next Page
Loading...