The operator must always make sure that the safety-relating and machine-technical installations
are approved by an expert before operation for the fi rst time and after any further changes
are made.
The operator has to make sure that the safety-relating and machine-technical installations are
approved by an expert after every four years in the form of an acceptance test.
The operator has to make sure that the safety-relating and machine-technical installations are
approved by a qualifi ed person once a year.
PROCEDURE
When hanging, the unit must not be installed in areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not
limited to) calculating working load limits, installation materials being used, and periodic safety
inspection of all installation materials and the unit. If you are not qualifi ed, do not attempt the
installation yourself, but instead use a professional structural rigger. Improper installation can
result in bodily injury and or damage to property.
The unit has to be installed out of the reach of people.
CAUTION: Units in overhead installations may cause severe injuries when falling! If you have
doubts concerning the safety of a possible installation, do not install the unit.
Mount the unit with the bracket to your hanging system using an appropriate clamp or bolt.
For overhead use, always install a safety wire which can hold at least 12 times the weight of the
unit. You must only use safety wires with link screw caps.
The maximum drop distance must never exceed 20cm.
A safety wire which has already held the strain of a fallen item or which is defective must not be
used again.
Adjust the desired installation angle via the mounting bracket and tighten the screws.
R I G G I N G
DANGER TO LIFE!
Before operation for the fi rst time, the
installation has to be approved by an expert!
To Next Page
Loading...