STARTING OPERATION
Install the unit on a level surface.
The fl uid tank of the unit needs to be fi lled with bubble fl uid before switching on.
Always disconnected it from the mains supply as fl uid could be spilled.
Only use quality bubble fl uids recommended by your dealer. We recommend high quality
bubble fl uids. You must not use substances which are classifi ed as
“DANGEROUS WORKING MATERIALS” or “FLAMMABLE FLUIDS”.
If fl uid should get inside the main housing, disconnect the unit from the mains immediately and
consult a technician.
INSTALLATION
Install the unit in a well-ventilated area. Use in an insuffi ciently ventilated room can lead to the
condensation of the bubble fl uid. The resulting slippery surface can cause accidents. Keep a
minimum distance of 20cm around the unit.
Furthermore do not orientate the output directly in the direction of the audience’s eyes. In order
to create the best effect, there should be a distance between the unit and the audience of at least
1.5M.
Only install the bubble machine on fi re resistant, scratch resistant and water resistant surfaces.
Please make sure that the installation angle does not exceed 15˚.
This unit is constructed for a free standing or hanging installation. If the unit is to be installed
overhead, please follow the safety instructions below:
RIGGING INSTALLATION
The installation has to be built and constructed in a way that it can hold 10 times the weight of the
unit(s) to be installed for 1 hour without any deformation.
The unit must always be secured with a secondary safety attachment, e.g. an appropriate catch
net or safety wire. The secondary safety attachment must be constructed in a way that no part of
the installed unit can fall down if the main attachment fails.
When rigging, derigging or servicing, do not allow personnel to be directly underneath the unit.
O P E R A T I O N
DANGER OF FIRE!
When installing the unit, make sure there is no highly fl ammable
material (decoration articles etc) within a minimum distance of 0.5M
To Next Page
Loading...