Manual Operation of The timer remote:
Once the bubble machine is plugged in, plug the timer remote into the “REMOTE INPUT” socket
on the rear of the unit. Now press the red “POWER” button to turn both the unit and remote on, the
above red LED will illuminate to indicated that the unit is receiving power.
When the green LED is illuminated above the “ON/OFF” button, this indicates that the unit is ready
to emit bubbles. Simply press the “ON/OFF” button to emit bubbles for your desired length of time.
Note: If the green LED above the “ON/OFF” button is illuminated and no bubbles appear after
pressing the “ON/OFF” button for 30 seconds, unplug the unit and check the fl uid tank and hose to
make sure that there are no blockages and that the fl uid is running through the hose.
Timer Operation of the remote:
The timer function allows the unit to emit bubbles at designated intervals.
To designate timed intervals, press the yellow “TIMER” button and the above yellow LED
will illuminate. Now rotate the “DURATION” and “INTERVAL” controls to set the desired
intervals. When you no longer need the timer operation, simply de-press the “TIMER” button.
Duration control: This control turns the timer on/off and sets the length of time of each output.
Interval control: This control sets the amount of time between each output from 30 secs - 10 mins.
CAUTION: Before removing or replacing the remote, please disconnect the mains power supply.
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the unit. Please use a soft lint-free and moistened cloth.
Never use alcohol or solvents!
Clean the output bubble wands frequently from bubble fl uid residues.
The bubble fl uids we recommend are non-hazardous to the environment and can be
disposed of via the sewage system.
There are no serviceable parts inside this unit except for the fuse. Maintenance and service
operations are only to be carried out by authorized dealers.
O P E R A T I O N
DANGER TO LIFE!
Disconnect from the mains before
starting maintenance
To Next Page
Loading...