Fonexion ideus ITCAB200 - Setting Pabx Code; Setting Dialing Mode

USER GUIDE
ITCAB200
EN
23
Press SET key again, LCD displays CODE- - - - -
Press ▲ or ▼ key to set the rst digit of local area code;
Press SET key to conrm and enter the second digit setting,
by using the same method to set the last 4 digits.
Unit will save and quit after 12 seconds.
Note:
If the local area code only 4 digits, the last digit can be left
as “-”.
After set the local area code, unit will auto-lter the area
code if the incoming call number with the rst several bits as
same as the local area code.
SETTING PABX CODE
At on hook state, press SET key
Press ▲ key twice, LCD displays SET 3 PCODE.
Press SET to conrm, LCD displays PCODE--
The rst “-“ ashes and indicates to set the rst code.
Press ▲ or ▼ key to set the rst code, Press SET key to
conrm to enter the next one.
Unit will save and quit after 12 seconds.
Note:
If only one digit of PABX code, left the second digit as“-“.
If set PABX code, when dialing back incoming call, and if the
incoming number is more than 6 digits, unit will auto-add
PABX ahead the number and pause 1 second.
SETTING DIALING MODE
At on hook state, press SET key
Press ▲ key four times, LCD displays SET 5 P-T
Press SET to conrm, LCD displays TONE
Press ▲ or ▼ key to select PULSE or TONE
Press SET to conrm.
Unit will save and quit after 12 seconds.
SETTING LCD CONTRAST FUNCTION
In on-hook state, press SET key and then press ▲ key sixth, LCD