THE FOODSAVER USER MANUAL
19
How to Vacuum Package Using FoodSaver Bottle Stoppers
THE FOODSAVER USER MANUAL
18
5 Close the lid. Lock the lid by
pressing in the locks on both sides.
(You may need to press down
lightly on the stars while pressing
in the locks.)
6 Press and hold down the On
button. The light will turn on as
the Vac 550 starts the vacuum cycle
and air is removed from the bottle.
Wait until the sound stops and
the light goes off before releasing
the lid.
7
Remove the accessory hose from the bottle stopper.
8 Vacuum packaging is complete.
How to Remove the FoodSaver Bottle Stopper
To remove the FoodSaver Bottle Stopper, simply twist and pull
up on the bottle stopper to release the vacuum.
IMPORTANT: Remember to remove the accessory hose from the
accessory port on the Vac 550 before you vacuum package in
FoodSaver Bags.
FoodSaver Bottle Stoppers are the best way to keep wine, oils, and
non-carbonated bottled liquids fresh longer. You will keep their
delicate taste from going stale by not exposing the liquids to air.
FoodSaver Bottle Stoppers are not to be used with plastic bottles.
Also, do not use with any carbonated or sparkling beverages.
Carbonation happens under pressure. A vacuum removes this
pressure, releasing the bubbles and causing the beverages to
become flat.
1 Place the Vac 550 on a flat, dry surface and plug the power cord
into a standard electrical outlet.
2 Insert the bottle stopper into the neck of the bottle. Leave at
least one inch between the contents and the bottom of the
bottle stopper.
3 Insert one end of the accessory
hose into the accessory port on
the Vac 550.
4 Insert the other end of the accessory
hose into the hole on the top of the
bottle stopper.
To Next Page
Loading...
Need help?
General
