Your scale has been factory calibrated. This function allows you to field calibrate your scales by setting
the zero and span for each scale with known weights.
Enter which scale you want to calibrate. Choice "1", "2", 3" or "4"
ENTER SCALE
NUMBER X
Action Required - Press "ENTER" after completing each step
Digital Display / Default (in red)
NOTE:
DEL FACTORY CAL ?
1 = Y 0 = N X
Do you want to DELETE THE FACTORY CALIBRATION ?
Enter "1" for YES, or "0" for NO. If answered "Y", you will see next question.
WAIT ....
Wait for further instructions.
REMOVE ALL WEIGHT
THEN PRESS ENTER
For Applications: Place test weight(s) on scale.
APPLY WEIGHT
THEN PRESS ENTER
GROSS WEIGHT
SCALE X = XXXX
Your scale is now calibrated and goes into the gross weight display mode.
All Chlor-Scales, Chem-Scales and Drumm-Scales are factory calibrated for your specific
application. Should you notice any error, field calibration can be performed as follows:
WAIT....
Wait for further instructions.
ENTER VALUE
XXXX
For Applications: Key in the combined gross weights (net
WEIGHT contents and tare weights) using the key pad then press enter.
For Applications: Key in the test weight(s) using the key pad,
then press enter.
CL2 & SO2
ALL OTHER
To set your "ZERO", remove all weight from the scale.
For Applications: Place full container(s) on scale.
For Applications. Consult Factory
ALL OTHER
CL2 & SO2
CHEM and DRUM SCALES
9081 FIELD CALIBRATION
1150-D Burnett Ave, Concord, CA 94520 USA
1-800-893-6723 US & Canada, Fax: 925-686-6713
www.forceflow.com / info@forceflow.com
File: T4\O&M\AWZMSTR\WZSETUP6.tcw (B19.pdf)
QUESTIONS ? Help Hotline: 1-800-893-6723
FORCE FLOW
FORCE FLOW
F
F
L
L
O
O
Q
Q
I
I
U
U
P
P
W.3.101
To Next Page
Loading...