INSTALLATION INSTRUCTIONS
Two (2) Adjustable Wrenches
Screw Driver and Tape Measure
Hammer (for pounding in anchor bolts)
Carboy/Drum (for aligning platform)
To prevent possible personal injury or damage to the equipment
through misuse, this equipment should be installed, operated and
serviced only by trained, qualified personnel who are thoroughly familiar with the
entire contents of this Instruction Manual, which should be thoroughly reviewed and
understood prior to installing and operating the equipment.
Power Drill and Drill Bits
Hammer Drill and Masonry Bit (5/16")
Two (2) 1/4" Diameter Anchors (for platform)
Four (4) properly chosen Anchors (for Indicator)
Your Electronic CARBOY-SCALE consists of two basic assemblies:
1. Load Cell System (Load Cell, Cable and Indicator)
2. PVC Platform (Backstop, Platform with Hinge and leveling shims)
Electronic CARBOY-SCALE
If you have any questions regarding the installation, operation or maintenance on your
CARBOY-SCALE, please do not hesitate to call our.... HELP HOTLINE 1-800-893-6723.
COMMENTS:
ITEMS REQUIRED FOR INSTALLATION:
WARNING:
FORCE FLOW
FORCE FLOW
F
F
L
L
O
O
Q
Q
I
I
U
U
P
P
1150-D Burnett Ave, Concord, CA 94520 USA
1-800-893-6723 US & Canada, Fax: 925-686-6713
WWW.FORCEFLOW.COM / INFO@FORCEFLOW.COM
REF: T4\O&M\CARBWIZ\CARBO&M1.tcw (L02.pdf)
S.1.103
W.1.103
To Next Page
Loading...