1. Slide the Bearing Rod (22) through the Sliding Frame (10) so that it is exposed on either
side
2.
Attach the Right Hand Stand (16) to the Sliding Frame (10) with M10x25 Bolt (65),
Washers (62) and M10 Nut (59)
3. Attach the Long Barbell Bushing Frame (31) to the Bearing Rod (22) with the M8x12
Allen Bolt (47)
4. Add the Barbell Buffer (32) and Spring Clip (45)
5. Repeat on the other side to attach the Left Hand Stand (15) and associated components
To Next Page
Loading...
