Force USA JX-1600 User Manual

Attention:
Please read all
instructions carefully
before using the
product.
Contents
Safety Information
Components-Parts
Components-Fixings
Assembly Instructions
Parts List
Model:
JX-1600
Retain this
manual for
reference
2017-02-13
OWNER’S
MANUAL
JX-1600
Corporate Multi-Station Gym - 4 station
dual stack with 154lbs each stack

Force USA JX-1600 Specifications

General

Brand	Force USA
Model	JX-1600
Category	Home Gym
Language	English

Summary

Before You Begin

Safety Information

Warning

Important safety precautions to follow during assembly and use of the equipment.

Care and Maintenance

Guidelines for periodic lubrication, cleaning, and tightening of equipment parts.

Rope Tension Adjustment

Instructions on how to adjust the rope system tension by moving the lower pulley.

Components - Fixings

Components - Parts (1)

Components - Parts (2)

Assembly Instructions

Step 1: Assemble Base Frame Components

Assemble the main base frame with guide rods, bumpers, and shock springs.

Step 2: Attach Side Base Support

Connect the side base support frame to the main base frame and add cross beam.

Step 3: Connect Rear Base Support

Attach the flat bracket to the rear base support and connect to the main base frame.

Step 4: Assemble Leg Press Frame

Attach leg press block frame, backrest support, and seat pad to the side base support.

Step 5: Install Leg Press Supports

Attach leg press rear and front supports to the outer adjust tube and side base support.

Step 6: Attach Sit Up Base Frame

Attach sit up base frame and board to the leg press backrest support.

Step 7: Assemble Chin Up Bar Support

Assemble chin up bar support and upper frame.

Step 8: Install Weight Stacks

Assemble weight plates, selector stem, and guide rods for the weight stacks.

Step 9: Attach Guide Rod Holders

Attach left and right guide rod holders to the guide rods and upper frame.

Step 10: Connect Power Tower Frame

Attach the power tower frame to the main base frame and connect guide rod holders.

Step 11: Attach Dip Arms and Handles

Attach L&R dip arms to the power tower frame and insert VKR handles.

Step 12: Assemble Front Press and Supports

Connect front press frame, pulley brackets, and supports.

Step 13: Attach Butterfly Frames and Handles

Attach butterfly frames and press handles.

Step 14: Connect Push Up Tubes and Handles

Connect push up tubes and handles.

Step 15: Attach Arm Curl Pads and Backrest Pad

Attach arm curl pads and backrest pad.

Step 16: Install Leg Press Handles

Attach leg press handles and adjustable tube.

Step 17: Cable Loop Diagram (Upper Cable)

Route upper cable through pulleys and frame.

Step 18: Butterfly Cable Connection

Connect butterfly cable to pulleys and frames.

Step 19: Lower Cable Loop Diagram

Route lower cable through pulleys and frame.

Step 20: Leg Press Cable Diagram

Route leg press cables through pulleys and frames.

Step 21: Attach Pads and Foam Roll Tubes

Attach pads and foam roll tubes to supports.

Step 22: Install Weight Stack Covers

Attach weight stack covers.

Step 23: Attach Final Pads and Foam Rolls

Attach final pads and foam rolls to supports.

Step 24: Connect Lat Bar and Short Bar Holder

Connect lat bar and short bar holder to cables.

Parts List